User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
116 R110/R170XiIIIPlus User Guide
Routine Maintenance
Clean Interior
9. Press down on the loops to lock the snap plate into place.
Cutter
If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.
To clean the cutter, complete these steps:
1. Turn Off (O) the printer.
2. Unplug the power cord.
3. Clean the stationary cutter blade with solvent.
If this does not remove label fragments and adhesive, contact an authorized service
technician.
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.