User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
Routine Maintenance
Clean Interior
R110/R170XiIIIPlus User Guide 115
Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside of the snap plate.
This illustration shows snap plate and the loops on either side.
To clean the snap plate, complete these steps:
1. Insert a small-blade screwdriver or similar tool into the loop on the left side of the snap
plate.
2. Gently lift the left side of the snap plate.
3. Insert a small-blade screwdriver or similar tool into the loop on the right side of the snap
plate.
4. Gently lift the right side of the snap plate.
5. Remove the snap plate from the printer.
6. Clean the snap plate with cleaning solvent and a soft cloth.
7. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into the two
slots of the media path.
8. Slide the snap plate toward you.
1
Left loop
2
Snap plate
3
Right loop
Important • Take care not to bend, twist, or otherwise deform the loops. If the snap plate
is damaged in any way, you may need a new plate for proper ribbon sensing.
1
2
3