User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
Memory Cards
CompactFlash Card
R110/R170XiIIIPlus User Guide 107
To install a CompactFlash card, complete these steps:
1. Turn the AC power Off (O).
2. Disconnect the AC power cord from the printer.
3. Remove the two screws near the bottom of the electronics cover.
4. Lift the electronics cover at the rear top corner. Pull the corner forward and up, then lift the
cover up and away from the printer.
5. Insert the CompactFlash card into the card slot on the upper portion of the option board.
Insert the card with the back (unlabeled) side of the card facing out. The card can be
inserted only one way and should snap into place.
The following illustration shows where to insert the CompactFlash card.
Caution • This procedure should only be performed by qualified service technicians.
Caution • Observe proper electrostatic safety precautions when handling any static-sensitive
components such as circuit boards and printheads.
1
Option board
2
Card slot
3
Compact flash card
1 2 3