User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
90 R110/R170XiIIIPlus User Guide
RFID Guidelines
ZPL II Commands for RFID
Example 2 • This example sets the printer to move the media to 800 dots from the top of
the media [or label length - 500 from the bottom (leading edge) of the media] and prints
“void” 500 dots in vertical length (Y axis) in case of an error.
^XA
^RS,800,500,2,P^FS
^XZ
The following illustration shows the resulting voided label. Note where the void starts. The
media has been moved 800 dot rows from the top of the label [label length minus 800 dot
rows from the bottom (leading edge) of a label] to bring the transponder into the effective
area to read/write a tag. If the printer fails the operation, an area that is 500 dot rows of the
media is voided instead of the entire rest of the media.
Top of label
Start of RFID
operation
800 dot rows
Bottom of label
Label length minus
800 dot rows
500 dot rows