User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
86 R110/R170XiIIIPlus User Guide
RFID Guidelines
ZPL II Commands for RFID
^HV
Host Verification
Description This command is used to return data from specified fields, along with an
optional ASCII header, to the host. It can be used with any field that has been assigned a
number with the
^RT command.
Format
^HV#,n,h
The following table identifies the parameters for this format.
Parameters Details
# = field number specified
with another command
The value assigned to this parameter should be the same as the one used in
the
^RT or ^RI command.
Accepted values: 0 to 9999
Default value: 0
n = number of bytes to be
returned
Accepted values: 1 to 256
Default value: 64
h = header Header (in uppercase ASCII characters) to be returned with the data.
Acceptable values: 0 to 3072 characters
Default value: none