User Manual

82 R110/R170XiIIIPlus User Guide
RFID Guidelines
ZPL II Commands for RFID
^WT
Write Tag
Description The ^WT command allows you to program the current RFID tag.
Format
^WTb,r,m,w,f,v
The following table identifies the parameters for this format.
Note • Check the amount of data memory available for the tag that you will be using. If more
is sent than the memory can hold, the data will be truncated.
Parameters Details
b = block number* Accepted values: 0 to n, where n is the maximum number of blocks for the tag.
Default value: 0
r = number of retries Accepted values: 0 to 10
Default value: 0
m = motion Accepted values:
• 0 (Feed label after writing.)
• 1 (No Feed after writing. Other ZPL may cause a feed.)
Default value: 0
w = write protect Accepted values:
• 0 (Not write protected.)
• 1 (Write protect.)
Default value: 0
f = data format Accepted values:
• 0 (ASCII)
• 1 (Hexadecimal)
Default value: 0