User Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
76 R110/R170XiIIIPlus User Guide
Configuration
ZebraNet PrintServer II LCD Displays
ZebraNet PrintServer II LCD Displays
The following menu options display only if you have a ZebraNet PrintServer II (PSII)
installed.
Table 2• Front Panel LCD Messages for PSII
LCD Explanation
IP RESOLUTION IP Resolution
Depending on the selection, allows either the user (permanent) or the server
(dynamic) to select the IP address. For more information, see the PrintServer II™
Installation and User Guide.
• Press the right or left oval to display other choices.
Default: Dynamic
Selections: Dynamic, permanent
IP PROTOCOLS IP Protocols
If Dynamic was chosen in the previous parameter, this selection determines the
method(s) by which the PrintServer II receives the IP address from the server. For
more information, see the PrintServer II™ Installation and User Guide.
• Press the right or left oval to display other choices.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP
IP ADDRESS IP Address
This parameter allows you to select the IP address if Permanent was chosen in IP
RESOLUTION. (If Dynamic was chosen, the user cannot select the address.) For more
information, see the PrintServer II™ Installation and User Guide.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.