User's Manual

Print Modes
Select a Print Mode
R110/R170XiIIIPlus User Guide 43
Cutter Mode
A cutter is a rotating knife with a self-sharpening blade that is attached to the front of the
printer. The cutter is used to cut individual labels as they are printed. See
www.zebra.com for
more information about the cutter option.
This illustration shows the printer loaded with labels in Cutter Mode.
To set up the printer in Cutter Mode, complete these steps:
1. Turn the printer On (I).
2. From the front panel, select Cutter Mode.
3. Open the printhead.
4. Slide the media guide and media supply guide as far from the printer frame as possible.
5. Flip down the media supply guide.
6. Put the roll of media on the media hanger.
7. Push the label core toward the printer frame. The labels must be aligned with the label
core.
8. Feed the media under the media guide roller and under the printhead.
9. Feed the labels through the cutter mechanism.
10. Flip up the media supply guide.
1
Printhead lever
2
Media guide
3
Media supply guide
4
Media
5
Cutter
Caution • The cutter blade is sharp. Do not rub or touch the blade with your fingers.
1
2 3
4
5