User's Manual

Printer Operation
Print a Configuration Label
R110/R170XiIIIPlus User Guide 29
Print a Configuration Label
When you have loaded the media and ribbon (if necessary), print a configuration label to use
as a record of your printer settings. Keep the configuration label for baseline information on
your printer when troubleshooting printing problems.
To print a configuration label, complete these steps:
1. Connect the power cord to the power connection on the back of the printer.
2. To confirm the power connection, turn the printer On (I).
The printer performs the power-up self test (POST). When the test is complete,
PRINTER READY displays on the front panel LCD.
3. Does the front panel LCD display PRINTER READY?
• Ye s — continue with the next step.
• No — go to Troubleshooting on page 119.
4. Turn the printer Off (O).
5. Press and hold CANCEL while turning the printer On (I).
6. Release CANCEL when the DATA light turns off (approximately five seconds).
The configuration label prints. A sample label, which may look different than
yours, is shown below.
Caution • For personal and equipment safety, always use an approved three-conductor power
cord specific to the region or country intended for installation. This cord must use an IEC 320
female connector and the appropriate region-specific three-conductor grounded plug
configuration.