User's Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
R110/R170XiIIIPlus User Guide 19
CHAPTER 3
Printer Operation
If you have completed the tasks and resolved the issues in the checklist in Before You Begin
on page 8, follow the instruction in this chapter to load and calibrate your printer and to print a
configuration label.
Contents
Load the Printer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Load Roll Media . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Load Fanfold Media. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Load Ribbon . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Remove Used Ribbon . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Print a Configuration Label . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
Calibrate the Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Adjust Sensors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Media and Ribbon Sensor Calibration. . . . . . . . . . . . . . . . . . 32
Transmissive (Media) Sensors . . . . . . . . . . . . . . . . . . . . . . . 34
Adjust the Printhead . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37