User's Manual

156 R110/R170XiIIIPlus User Guide
Index
ribbon
CHECK RIBBON light on, 32
create ribbon leader, 24
load, 24
removal, 28
RIBBON IN message, 123
ribbon LED setting, 74
ribbon low warning, 60
Ribbon Out message, 121
setting length, 61
specifications, 144
troubleshooting wrinkles, 128
when used, 18
ribbon sensor
calibration procedure, 64
cleaning, 113
location, 113
sensitivity calibration, 31
when to clean, 110
Ribbon S. setting, 74
roll media loading, 20
routine maintenance, 109
RS-232 interface connections, 98
RS-422/RS-485 interconnections, 101
RTC (Real-time clock) setting
date, 75
time, 75
S
schedule for cleaning, 110
select a printer site, 10
selecting a print mode, 40
self tests
CANCEL, 132
FEED, 134
FEED and PAUSE, 135
how to perform additional tests, 131
PAUSE, 133
Power-On Self Test (POST), 131
Sensor Profile calibration
description, 31
procedure, 63
sensors
adjusting, 32
cleaning, 113
label-available sensor location, 113
lower media sensor adjustment, 36
media and ribbon sensor calibration, 32
ribbon sensor location, 113
setting sensor type, 58
transmissive (media) sensor adjustment, 34
transmissive (media) sensor location, 113
upper media sensor adjustment, 34
serial port
location, 13
pin configuration, 97
settings, 96
setting serial communications, 65
setup checklist, 8
setup mode
enter setup mode, 54
LCD messages, 57
leave setup mode, 54
shipping
report damage, 9
reship the printer, 9
short calibration, 31
site requirements, 10
“smart” labels, 17
snap plate
cleaning, 115
when to clean, 110
spacing requirements, 10
specifications
by model number, 142
electrical, 141
environmental, 141
general, 141
power cord, 11
ribbon, 144
standard data ports, 94
standard features, 138
start print signal setting, 73
store the printer, 9
subnet mask setting, 77
support, xx
surface for the printer, 10