User's Manual
Table Of Contents
- Table of Contents
- Printer Software and Firmware License Agreement
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Print Modes
- Configuration
- RFID Guidelines
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Index
88 R110/R170XiIIIPlus User Guide
RFID Guidelines
ZPL II Commands for RFID
e = error handling Send an error message to the host as an unsolicited message for each failure
and set the printer in error mode.
Accepted values:
• N = No action
• P = Place printer in Pause
• E = Place printer in Error
Default value: N
Note • To enable or disable the unsolicited error message, refer to the
^SX
and
^SQ commands. The parameter for the RFID error in these commands
is
V.
*Not applicable for R110/R170XiIIIplus
Parameters Details