User's Manual Part 2
56 R110PAX4 User Guide 58981L-002 Rev. 1 2/11/05
Print Engine Configuration
Front Panel LCD
Adjust Slew Speed
Adjusts the speed for feeding a blank label (given in inches per second).
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: 6 IPS
Range: 1 to 12 IPS
Adjust Backfeed Speed
If backfeed is on, adjusts the speed at which the label backs up before
printing (given in inches per second).
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: 2 IPS
Range: 1 to 12 IPS
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing. Positive numbers move the media out
and negative numbers move the media in.
Each press of an oval adjusts the tear-off position by four dot rows.
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: +0
Range: –120 to +120
Select Print Mode
Print mode settings tell the print engine the method of media delivery that
you wish to use.
• Press either oval to display other choices.
Default: APPLICATOR
Selections: TEAR-OFF, REWIND, APPLICATOR
Set Media Type
This parameter tells the print engine the type of media that you are using.
Selecting continuous media requires that you include a label length
instruction in your label format (
^LLxxxx if you are using ZPL or
ZPL II).
When non-continuous media is selected, the print engine feeds media to
calculate label length (the distance between two recognized registration
points of the inter-label gap, webbing, or alignment notch or hole).
• Press either oval to display other choices.
Default: NON-CONTINUOUS
Selections: CONTINUOUS, NON-CONTINUOUS
Table 6 • Print Engine Parameters (Page 2 of 19)
Parameter Action/Explanation
SLEW SPEED
6 IPS +
BACKFEED SPEED
2 IPS +
TEAR OFF +000
- +
PRINT MODE
-APPLICATOR +
MEDIA TYPE
-NON-CONTINUOUS+