User's Manual Part 2

58981L-002 Rev. 1 2/11/05 R110PAX4 User Guide 185
Index
A
adhesive test for ribbon coating, 30
adjustments
LCD, 71
left position, 68
media sensors, 46
print engine darkness, 55
printhead pressure, 128
tear-off position, 56
toggle positioning, 127
advanced counter reset, 106
applicator
applicator interface connector, 163
as part of a labeling system, 7
install print engine, 21
interface pin configuration, 168
setting applicator port mode, 69
signals during applicator modes, 163
authentication type, 75
auto-calibration, 44
B
backfeed setting, 68
bar codes
list available codes, 60
specifications, 152
baud setting, 64
before you begin setup, 14
bitmap scaling factor, 72
black mark media
described, 27
setting sensor type, 57
black oval button descriptions, 9
buttons on front panel, 9
C
cable requirements, 26
calibration
CALIBRATE button description, 10
media and ribbon sensor, 63
methods, 44
RFID tag from front panel, 77
RFID tag using ZPL (^HR), 96
setting for head close, 67
setting for media power up, 67
CANCEL button description, 10
CANCEL self test, 143
characteristics of transponders, 85
checklist
before you begin, 14
troubleshooting, 132
Class 0 and 0+ transponder characteristics, 85
Class 1 transponder characteristics, 85
cleaning
exterior of print engine, 122
interior, 123
printhead and platen roller, 125
recommended schedule, 122
communication interfaces
overview and location, 24
types of connections, 157
communications diagnostics test
overview, 148
selecting, 65