User's Manual Part 2

162 R110PAX4 User Guide 58981L-002 Rev. 1 2/11/05
Data Ports
Serial Port
DB-9 to DB-25 Connections
An interface adapter is required (Zebra part number 33109M) to connect the print engine’s
DB-9 interface to a DB-25 connector. A generic DB-25 adapter CAN be used, although the
+5 VDC signal source would not be passed through the adapter.
Figure 56 shows the connections required for the DB-9 to DB-25 interface.
Figure 56 • DB-9 to DB-25 Connections
Modem Connection
When the print engine is connected via its RS-232 interface to Data Communication
Equipment (DCE) such as a modem, use a standard RS-232 (straight-through) interface cable.
Figure 57 shows the connections required for this cable.
Figure 57 • RS-232 Connections
Male DB-9 Adapter
Connector
(plugs into printer)
Female DB-25 Adapter
Connector
(plugs into cable)
NOTE: Pin 1 of DB-9 connector is unused and unterminated.
FG
TXD
RXD
RTS
DSR
SG
DTR
RXD
TXD
DTR
SG
DSR
RTS
CTS
+5 VDC
SIGNAL
2
3
4
5
6
7
8
9
1
2
3
4
6
7
9
20
+5 VDC
SIGNAL
5
CTS
DTE
(Printer)
DCE
(Modem, etc.)
RXD (receive data)
TXD (transmit data)
DTR (data terminal ready)
SG (signal ground)
DSR (data set ready)
RTS (request to send)
CTS (clear to send)
+5 VDC signal source
NOTE: Pin 1 is unused and unterminated at the printer.
2
3
4
5
6
7
8
9
2
3
4
5
6
7
8
9