User's Manual Part 2

154 R110PAX4 User Guide 58981L-002 Rev. 1 2/11/05
Print Engine Specifications
Media Specifications
Media Specifications
Media width
(label and liner)
Minimum Non-RFID 0.625 in. (16 mm)
RFID “smart” labels Minimum label widths for RFID “smart” labels
varies for each transponder type.
Maximum 4.5 in. (114 mm)
Label length Minimum Non-RFID, applicator
mode
0.5 in. (12.7 mm) with backfeed on
0.25 in. (6 mm) with backfeed off
Non-RFID, tear-off
mode
0.5 in. (12.7 mm) with backfeed on
0.25 in. (6 mm) with backfeed off
RFID “Smart” labels Minimum label length for RFID “smart” labels
varies for each transponder type.
Registration tolerance
(not including label/liner
position tolerances)
Ver ti cal
(concurrent labels)
±0.040 in. (±1.0 mm)
(in Applicator mode)
Horizontal ±0.040 in. (±1.0 mm)
Total thickness (including liner) 0.0058 in. to 0.010 in. (0.148 mm to 0.256 mm)
Interlabel Gap
(Transmissive Sensor)
Minimum 0.079 in. (2 mm)
Preferred 0.118 in. (3 mm)
Maximum 0.157 in. (4 mm)
Notch Size (W x L) 0.25 in. x 0.12 in. (6 mm x 3 mm)
Position On inside edge, <0.8 in (<20 mm) from leading
edge of media
Hole Minimum 0.125 in. (3.2 mm)
Position 0.25 to 3.0 in. (6.3 to 76.2 mm) from inside edge
<0.8 in. (<20 mm) from leading edge of media
Black Mark
(Reflective Sensor)
Vertical length (parallel
to inside media edge)
0.12 in. to 0.43 in. (3 mm to 11 mm)
Horizontal width
(perpendicular to inside
media edge)
≥0.43 in. (≥ 11 mm)
Position Within 0.04 in. (1 mm) of the inside edge and
<0.8 in (20 mm) from leading edge of media
Print Line to Peel Bar Distance 0.464 in. (11.8 mm)
Media Unwind Force Steady State Must be uniform and must not exceed
2lb(907g)
Transient (Start/Stop) Must not exceed 4 lb (1814 g)
Media Rewind Force Applicator take-up pull tension must be uniform
from 1 to 4 lb (454 to 1818 g) and must not vary
more than ±20% during operation.