User's Manual Part 1

Getting Started
Connect the Print Engine to a Power Source
58981L-002 Rev. 1 2/11/05 R110PAX4 User Guide 23
Power Cord Specifications
Depending on how your print engine was ordered, a power cord may or may not be included.
If one is not included or if the one included is not suitable for your requirements, refer to the
following guidelines:
• The overall cord length must be less than 9.8 ft (3.0 m).
• The cord must be rated for at least 5 A, 250 V.
• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference. The third wire in the power cord grounds the connection (Figure 12).
Figure 12 • Power Cord Specifications
• The AC power plug and the IEC 320 connector must bear the certification mark of at least
one of the known international safety organizations shown in Figure 13.
Figure 13 • International Safety Organization Marks
1
AC power plug for your country
2
3-conductor HAR cable
3
IEC 320 connector
4
Contact view of plug—(a) neutral, (b) earth, (c) live
1 2 3 4
a
b
c
+
R