User's Manual Part 2

122 R110PAX3 User Guide 9/7/2004 58981L-001 Rev. 1
Print Engine Specifications
Media Specifications
Media Specifications
Media width
(label and
liner)
Minimum Non-RFID 0.63 in. (16 mm)
RFID “smart” labels Minimum label widths for RFID “smart” labels
varies for each transponder type.
Maximum 4.5 in. (114 mm)
Label length Minimum Non-RFID, applicator
mode
0.5 in. (12.7 mm) with backfeed on
0.25 in. (6 mm) with backfeed off
Non-RFID, tear-off
mode
0.5 in. (12.7 mm) with backfeed on
0.25 in. (6 mm) with backfeed off
RFID “Smart” labels Minimum label length for RFID “smart” labels
varies for each transponder type.
Registration tolerance
(not including label/liner
position tolerances)
Verti ca l
(concurrent labels)
±0.040 in. (±1.0 mm)
(in Applicator mode)
Horizontal ±0.040 in. (±1.0 mm)
Total thickness (including liner) 0.0058 in. to 0.010 in. (0.148 mm to 0.256 mm)
Interlabel Gap
(Transmissive Sensor)
Minimum 0.079 in. (2 mm)
Preferred 0.118 in. (3 mm)
Maximum 0.157 in. (4 mm)
Notch Size (W x L) 0.25 in. x 0.12 in. (6 mm x 3 mm)
Position On inside edge, <0.8 in (<20 mm) from leading
edge of media
Hole Minimum 0.125 in. (3.2 mm)
Position 0.25 to 3.0 in. (6.3 to 76.2 mm) from inside edge
<0.8 in. (<20 mm) from leading edge of media
Black Mark
(Reflective Sensor)
Vertical length (parallel
to inside media edge)
0.12 in. to 0.43 in. (3 mm to 11 mm)
Horizontal width
(perpendicular to inside
media edge)
0.37 in. (9.5 mm) minimum
Position One of the following:
• within 0.04 in. (1 mm) of the inside edge and
<0.8 in (20 mm) from leading edge of media
• centered within 0.23 in. to 2.25 in. (5.8 to
57 mm) from the media inner edge
Print Line to Peel Bar Distance 0.464 in. (11.8 mm)