User's Manual Part 2

116 R110PAX 3 User Guide 9/7/2004 58981L-001 Rev. 1
Troubleshooting
Print Engine Diagnostics
Communications Diagnostics Test
Do not perform the following test until all configuration and calibration parameters have been
set. For configuration information, see Front Panel LCD on page 55.
This test is controlled from the front panel display. See Set Communications Mode on page 64.
Figure 50 shows a typical printout from this test. Turn off the power to exit this self test and
return to normal operation.
Figure 50 • Communications Diagnostics Test Label
J11 Interface Fixed
J10 Interface Fixed
J9 Interface Fixed
J8 Interface Fixed
J7 Interface Fixed
Table 15 • Control of Print Engine Parameters
Parameter Controlled By
Note • The communications test label prints upside-down.