User's Manual Part 2

Routine Maintenance
Clean Interior
58981L-001 Rev. 1 9/7/2004 R110PAX 3 User Guide 91
Clean Interior
Remove any accumulated dirt and lint from the interior of the print engine using a soft bristle
brush and/or vacuum cleaner. This area should be inspected every time a new ribbon is loaded.
Clean the Sensors
To ensure proper operation of the print engine, all sensors should be cleaned on a regular basis.
The sensors are shown in the following:
• See Figure 39 for the media sensors.
• See Figure 40 on page 92 for the door-open sensor.
• See Figure 41 on page 92 for the ribbon sensor and ribbon sensor reflector.
Figure 39 • Media Sensor Locations
1
Upper transmissive media sensor
2
Reflective media sensor
3
Lower transmissive media sensor