User's Manual Part 2

RFID Guidelines
^WT
58981L-001 Rev. 1 9/7/2004 R110PAX 3 User Guide 85
^WT
Write Tag
Description The ^WT command allows you to program the current RFID tag.
Format
^WTb,r,m,w,f,v
The following table identifies the parameters for this format.
Note • Check the amount of data memory available for the tag that you will be using. If more
is sent than the memory can hold, the data will be truncated.
Parameters Details
b = block number* Accepted values:
• 0 (ID data/EPC)
• 1 (User data)
Default value: 0
r = number of retries The number of times that the command will be tried on the same tag.
Accepted values: 0 to 10
Default value: 0
m = motion Accepted values:
• 0 (Feed label after writing.)
• 1 (No Feed after writing. Other ZPL may cause a feed.)
Default value: 0
w = write protect* Accepted values:
• 0 (Not write protected.)
• 1 (Write protect.)
Default value: 0
f = data format Accepted values:
• 0 (ASCII)
• 1 (Hexadecimal)
Default value: 0
v = verify valid
data*
Default value: Y
Accepted values:
• N (Do not verify)
• Y (Verify valid data [Hex A5A5 in the first two bytes] before writing)
* Not applicable for R110PAX.