User's Manual Part 2

82 R110PAX3 User Guide 9/7/2004 58981L-001 Rev. 1
RFID Guidelines
^RS
Example 2 • This example sets the print engine to move the media to 800 dots from the top
of the media [or label length - 500 from the bottom (leading edge) of the media] and prints
“void” 500 dots in vertical length (Y axis) in case of an error.
^XA
^RS,800,500,2,P^FS
^XZ
The following illustration shows the resulting voided label. Note where the void starts. The
media has been moved 800 dot rows from the top of the label [label length minus 800 dot
rows from the bottom (leading edge) of a label] to bring the transponder into the effective
area to read/write a tag. If the print engine fails the operation, an area that is 500 dot rows of
the media is voided instead of the entire rest of the media.
Top of label
Start of RFID
operation
800 dot rows
Bottom of label
Label length minus
800 dot rows
500 dot rows