User's Manual Part 2

80 R110PAX3 User Guide 9/7/2004 58981L-001 Rev. 1
RFID Guidelines
^RS
s = signals on applicator When the value for parameter p (read/write position of the transponder) is
nonzero, this paramters changes the number of start and stop print signals
required for printing.
In single mode, one start print command is required. In double mode, two are
required, so the print engine will resume printing only after the second start
print command is received.
Accepted values:
• S (single) signal
• D (double) signal
Default value: S
r = RFID pre-read disable To optimize throughput, the RFID tag is pre-read to ensure that a transponder
is present before trying to write to it. This function can be disabled.
Accepted values:
• N (use RFID pre-read)
• Y (disable RFID pre-read)
Default value: N
Parameters Details