User's Manual Part 2

Print Engine Configuration
Front Panel LCD
58981L-001 Rev. 1 9/7/2004 R110PAX 3 User Guide 73
ZebraNet
®
Print Server LCD Displays
The menu options shown in Table 7 display only if you have the ZebraNet PrintServer II
installed.
Table 7 • Print Server LCD Displays
Parameter Action/Explanation
IP PROTOCOL
1
IP Protocol
Allows either the user (permanent) or the server (dynamic) to select the IP address.
If a dynamic option is chosen, this selection determines the method(s) by which the
print server receives the IP address from the server.
• Press the right or left oval to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND
BOOTP, PERMANENT
IP ADDRESS
1
IP Address
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the
address.)
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
SUBNET MASK
1
Subnet Mask
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
DEFAULT
GATEWAY
1
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
1. Press the left oval to move to the next digit position.
2. Press the right oval to increase the value of the digit.
1 These parameters appear after the system recognizes the existence of a ZebraNet print server. After the print server is
recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to address
192.168.254.254.