User's Manual Part 2

Print Engine Configuration
Front Panel LCD
58981L-001 Rev. 1 9/7/2004 R110PAX 3 User Guide 61
Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all
previously stored information from Flash memory.
1. Press the right oval to select YES. (If you are prompted to enter the
password, see Changing Password-Protected Parameters on page 54.
The display shows
INITIALIZE FLASH?
2. Press the right oval to select YES.
The display shows ARE YOU SURE?.
3. Do you wish to continue?
• Press the left oval to select
NO to cancel the request and return to the
INITIALIZE FLASH prompt.
• Press the right oval to select
YES and begin initialization.
When initialization is complete, the print engine automatically exits
Setup mode, and the front panel displays
PRINTER READY. If you
exit Setup mode while initialization is still in process, the front panel
display flashes between the phrases
CHECKING E: MEMORY and
PRINTER IDLE.
Note • Depending on the amount of free FLASH memory, initialization
may take up to 1 minute to complete.
Print Sensor Profile
The media sensor profile may be used to troubleshoot registration
problems that may be caused when the media sensor detects preprinted
areas on the media or experiences difficulty in determining web location.
• Press the right oval to start this standard calibration procedure and print
a media sensor profile.
Figure 38 shows a media sensor profile. If the sensitivity of the media
and/or ribbon sensors must be adjusted, use Calibrate Media and Ribbon
Sensor Sensitivity on page 62 to adjust sensor sensitivity.
Figure 38 • Media Sensor Profile
Table 6 • Print Engine Parameters (Sheet 7 of 18)
Parameter Action/Explanation
INIT FLASH MEM
YES
SENSOR PROFILE
PRINT