User's Manual Part 2

58 R110PAX3 User Guide 9/7/2004 58981L-001 Rev. 1
Print Engine Configuration
Front Panel LCD
Set Maximum Label Length
Maximum length is used in conjunction with the calibration procedure.
The value of this setting is the maximum label length that is used during
the media portion of the calibration process. Only a few labels are required
to set media sensors. The interlabel gap is considered part of the label
length and must be taken into consideration.
Always set a value that is at least 1 in. (25.4 mm) longer than the length of
the label you are using. For example, if the label length is 5 inches
(126 mm) including the interlabel gap, set the parameter for 6.0 inches
(152 mm). If the label length is 7.5 inches (190 mm), set the parameter for
9.0 inches (229 mm). If the value is set to a smaller value than the label
length, the print engine assumes that continuous media is loaded, and the
print engine cannot calibrate.
• Press the right oval to increase the value.
• Press the left oval to decrease the value.
Default: 39.0 inches (988 mm).
Range: Values are adjustable in one-inch (25.4 mm) increments.
Set Early Warning for Media
When this parameter is enabled, the print engine provides warnings when
labels are running low.
Note • Update the number of labels per roll when beginning use of the
Early Warning System. Also, the print engine does not make any
adjustments when power is turned off and on.
• Press the right or left oval to display other choices.
Default: MEDIA DISABLED
Selections: MEDIA DISABLED, MEDIA ENABLED
To change the Early Warning settings:
1. When the LCD displays EARLY WARNING, press the right or left
oval until the desired setting is listed on the LCD. (If you are
prompted for a password, enter your password using the instructions
in Changing Password-Protected Parameters on page 54.)
When the print engine detects that less than 15% of the labels remain,
WARNING MEDIA LOW appears on the LCD. If the alert function
has been enabled, an alert is also sent. When the printhead is opened
and then closed after a media warning has been received, the LCD
prompts with
MEDIA REPLACED?.
Press the right oval to select
YES to clear the warning and reset the
label counter.
2. When setting the Early Warning for maintenance, the LCD prompts
HEAD CLEAN?.
3. Press the right oval to select YES.
Table 6 • Print Engine Parameters (Sheet 4 of 18)
Parameter Action/Explanation
MAXIMUM LENGTH
-39.0 IN 988 MM
EARLY WARNING
MEDIA DISABLED