User's Manual Part 2

156 R110PAX3 User Guide 9/7/2004 58981L-001 Rev. 1
Index
print engine settings
applicator port, 68
backfeed, 67
baud, 63
calibration methods, 46
control prefix, 65
data bits, 63
date, 71
delimiter character, 65
format convert, 71
format prefix, 65
head resistor, 68
host handshake, 63
idle display, 71
IP settings, 73
label top, 67
language, 72
LCD, 70
left position, 67
maximum label length, 58
media type, 56
network configuration label as baseline, 45
network ID, 64
parallel communications, 62
parity, 63
print darkness, 55
print method, 57
print server settings, 73
print width, 57
protocol, 64
resynch mode, 69
saving, 52
sensor type, 57
serial communications, 63
setting through front panel, 52
start print signal, 69
time, 71
ZPL mode, 66
print engine setup
before you begin, 14
installation, 16
unpack the print engine, 15
print modes, 56
print network configuration label, 45, 60
print quality troubleshooting, 104
print server settings
default gateway, 73
IP address, 73
IP protocol, 73
subnet mask, 73
print width setting, 57
printhead
cleaning, 93
head close setting, 66
head resistor value setting, 68
pressure adjustment, 96
when to clean, 90
printing specifications, 121
proprietary statement, 137
protocol setting, 64
R
reflective media sensor, 48
related documents, 5
remove used ribbon, 43
report shipping damage, 15
reprint mode, 70
requirements for installation, 16
resynch mode setting, 69
RFID
error status, 72
guidelines, 75
RFID test, 72
sample ZPL commands, 87
“smart” labels, 28
transponder placement, 76
ZPL commands, 77
ribbon
adhesive test, 30
determining coated side, 29
loading, 38
low ribbon warning, 69
removal, 43
ribbon LED setting, 70
ribbon tensioning system parameters, 71
scratch test, 30
specifications, 123
when to use, 29
Ribbon S. setting, 70
ribbon sensor
calibration procedure, 62
location, 91
sensitivity calibration, 47
when to clean, 90
RS-232 interface
connections, 129
considerations, 25
RTC (Real-time clock) setting
date, 71
idle display, 71
time, 71