User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
Printer Operation
Loading the Media
23063L-003 Rev. A 6/24/05 R110Xi/R170Xi User Guide 23
Figure 14 • Threading Media
7. Pull the media through under the printhead.
8. Adjust the media guide so that it just touches but does not restrict the media. The labels
should lie flat.
9. Which type of media are you using?
1
Ribbon guide roller
2
Upper media sensor assembly
3
Media guide roller
4
Media guide
5
Media
If you are... Then...
Using direct thermal media Close the printhead, and then go to Print a Printer
Configuration Label on page 32.
Using thermal transfer media Go to Loading Ribbon on page 26.
Not sure Go to When to Use Ribbon on page 16.
4
2
1
5
3