User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
22 R110Xi/R170Xi User Guide 23063L-003 Rev. A 6/24/05
Printer Operation
Loading the Media
To load roll media, complete these steps:
1. Open the printhead.
2. See Figure 13. Slide the media guide away from the printer frame. You may need to
loosen the media guide thumb screw.
Figure 13 • Adjusting the Media Guide
3. Place the roll of media on the media hanger.
4. Push the media core toward the printer frame. Make sure that the labels are aligned with
the media core.
5. Adjust the media guide on the media hanger so it just touches but does not restrict the
media.
6. See Figure 14. Feed the media under the media guide roller and under the upper media
sensor assembly.
1
Media guide
2
Location of media guide thumb screw
3
Media guide on media hanger
4
Media hanger
Important • Be sure to thread the media under the upper media sensor assembly and the
ribbon guide roller. If you thread the media over these, the media blocks the ribbon sensor.
1
2
3
4