User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
20 R110Xi/R170Xi User Guide 23063L-003 Rev. A 6/24/05
Printer Operation
Loading the Media
Loading the Media
This section gives you a series of instructions to load labels for a standard printer in Tear-Off
mode (Figure 11). You can use roll or fanfold media in this printer. For more information about
the types of media, see Types of Media on page 14.
• To load roll media, see Load Roll Media on page 21.
• To load fanfold media, see Load Fanfold Media on page 24.
Figure 11 • Printer Loaded in Tear-Off Mode
Caution • Be sure the printer is Off (O) if you have connected the power cable.