User's Manual

168 R110Xi/R170Xi User Guide 6/23/05 23063L-003 Rev. A
Index
S
schedule for cleaning, 116
scratch test
media type, 16
ribbon coated side, 17
SCTIN-64 standard programming example, 82
select a printer site, 10
self tests
CANCEL, 135
FEED, 137
FEED and PAUSE, 138
how to perform additional tests, 134
PAUSE, 136
Power-On Self Test (POST), 134
Sensor Profile calibration
description, 36
procedure, 49
sensors
cleaning, 119
label-available sensor location, 119
lower media sensor adjustment, 38
ribbon sensor location, 119
setting sensor type, 45
transmissive (media) sensor adjustment, 37
transmissive (media) sensor location, 120
upper media sensor adjustment, 37
serial port
location, 12
pin configuration, 103
setting serial communications, 50
settings, 102
set RFID tag password (^RZ), 94
setup checklist, 8
setup mode
enter setup mode, 42
exit setup mode, 42
LCD messages, 44
shipping
report damage, 9
reship the printer, 9
short calibration, 35
site requirements, 10
“smart” labels, 15
snap plate
cleaning, 121
when to clean, 116
spacing requirements, 10
specifications
by model number, 143
electrical, 142
environmental, 142
general, 142
power cord, 11
ribbon, 145
specify number of retries for block (^RR), 86
specify RFID tag type, 63
standard data ports, 99
standard features, 140
start print signal setting, 57
store the printer, 9
subnet mask, 60
support, x
surface for the printer, 10
T
take label setting, 58
Tear-Off Mode
tear-off position adjustment, 45
Tear-Off mode
tear-off bar cleaning, 116
temperature requirements, 10
thermal transfer mode
load ribbon, 26
media scratch test, 16
setting, 46
time setting, 59
toggle pressure adjustment, 39
top of label
printer cannot detect, 133
setting, 55
transmissive (media) sensor
adjustment, 37
location, 120
when to clean, 116
transponders
calibrate from front panel, 63
calibration using ZPL (^HR), 78
characteristics of different types, 68
placement in labels, 66
selecting type, 68
setting tag type, 68
when to calibrate, 68