User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
RFID Guidelines
^WV
23063L-003 Rev. A 6/24/05 R110Xi/R170Xi User Guide 97
^WV
Verify RFID Write Operation
Description If write verify is enabled, this command verifies the RFID write operation to
ensure that the tag about to be programmed contains the hex data “A5A5” in the first two
bytes. This parameter is not persistent (carried over from label to label).
Format
^WVe
The following table identifies the parameters for this format.
Important • This command is valid with Class 1 Alien tags only.
Parameters Details
e =enable Accepted values: Y or N
Default value: N