User's Manual
Table Of Contents
- Contents
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Front Panel Controls
- RFID Guidelines
- Overview
- Getting Started with RFID
- Creating Basic RFID Label Formats
- RFID Label Format 1-Write a 96-bit Tag in Hexadecimal
- RFID Label Format 2-Write a 64-bit Tag in Hexadecimal
- RFID Label Format 3-Write a 96-bit Tag in ASCII
- RFID Label Format 4-Read Data from Tag and Print on Label
- RFID Label Format 5-Write Tag, Read Tag, and Print Data on Label
- RFID Label Format 6-Write Tag, Read Tag, and Return Results to Host
- ZPL II Commands for RFID
- Data Ports
- Memory Cards
- Routine Maintenance
- Troubleshooting
- Specifications
- Proprietary Statement
- Warranty Information
- Printer Software and Firmware License Agreement
- Index
94 R110Xi/R170Xi User Guide 6/24/05 23063L-003 Rev. A
RFID Guidelines
^RZ
^RZ
Set RFID Tag Password
Description This command lets you define the password for the tag during writing.
Format
^RZp
The following table identifies the parameters for this format.
Important • Only certain tags support this feature, so check to ensure that this command can
be used with your particular tag type.
Parameters Details
p = password Accepted values: 00 to FF (hexadecimal)
Default value: 00