User's Manual

87
Configuration
Front Panel LCD Displays
12/2/05 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-002 Rev. A
RFID LCD Displays
This section shows the Radio Frequency Identification (RFID) control panel parameters. The
parameters shown in Table 9 display only if you have an RFID reader installed.
When you enter Setup mode, press
PREVIOUS to access these parameters without having to
scroll through all of the other parameters.
Table 9 • RFID Parameters (Sheet 1 of 4)
Parameter Action/Explanation
Perform RFID Test
In both versions of this test, the printer attempts to read and write to a
transponder. In the slow test, the printer also checks the reader version
number. If the printer fails the test, the control panel displays an error
message. No label movement occurs with this test.
To perform the RFID test:
1. See Figure 39. Position an RFID label so that the transponder is over
the RFID antenna.
Figure 39 • Label Position for RFID Test
2. Press the left oval to select
QUICK.
OR
Press the right oval to select
SLOW.
3. If necessary, press the right oval to select
CONTINUE.
RFID TEST
QUICK SLOW
1
1
RFID antenna location