User's Manual

Configuration
Control Panel LCD Displays
76
13383L-002 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 12/2/05
Select Backfeed Sequence
This parameter sets when label backfeed occurs after a label is removed in
some print modes. It has no effect in Rewind mode. This setting is
superseded by
~JS when received as part of a label format (see ZPL II
Programming Guide Volume I).
Default: DEFAULT (90%)
Selections: DEFAULT, AFTER, BEFORE, 10%, 20%, 30%, 40%, 50%,
60%, 70%, 80%, OFF
To change the value shown:
1. Press the left or right oval to scroll through the options.
Adjust Label Top Position
This parameter adjusts the print position vertically on the label. Positive
numbers adjust the label top position farther down the label (away from the
printhead); negative numbers adjust the position up the label (toward the
printhead). The displayed value represents dots.
Default: +000
Range: –120 to +120 dots
To change the value shown:
1. Press the right oval to increase the value.
2. Press the left oval to decrease the value.
Adjust Left Position
This parameter establishes how far from the left edge of a label the format
begins to print by adjusting horizontal positioning on the label. Positive
numbers adjust the printing away from the main frame by the number of
dots selected; negative numbers shift printing toward the main frame. The
displayed value represents dots.
Default: 0000
Range: –9999 to +9999 dots
To change the value shown:
1. Press the left oval to move the cursor.
2. Press the right oval to change between +/- and to increase the value of
the digit.
3. For a negative value, enter the value before changing to the minus sign.
Table 7 • Printer Parameters (Sheet 20 of 26)
Parameter
Action/Explanation
BACKFEED
- DEFAULT +
LABEL TOP +000
- +
LEFT POSITION
- ±0000 +