User's Manual

Configuration
Setup Mode
52
13383L-002 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 12/2/05
Setup Mode
After you have installed the media and ribbon and the Power-On Self Test (POST) is complete,
the control panel displays
PRINTER READY. You may now set printer parameters for your
application using the control panel display and the buttons directly below it. If it becomes
necessary to restore the initial printer defaults, see PA U S E S e l f Te s t on page 137 and FEED
Self Test on page 138.
Enter Setup Mode
To enter Setup Mode, complete these steps:
1. Press SETUP/EXIT.
2. Press NEXT/SAVE or PREVIOUS to scroll through the parameters.
Important • Certain printing conditions may require that you adjust printing parameters,
such as print speed, darkness, or print mode. These conditions include (but are not limited
to):
printing at high speeds
peeling the media
the use of extremely thin, small, synthetic, or coated labels
Because these and other factors affect print quality, run tests to determine the best
combination of printer settings and media for your application. A poor match may limit print
quality or print rate, or the printer may not function properly in the desired print mode.
Note • If the printer is operating on an IP network, you can change the printers parameters
in these additional ways:
with ZebraLink™ WebView (ZebraNet
®
10/100 PrintServer or ZebraNet Wireless Print
Server required). For information, see the appropriate print server user guide.
with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For
information, see the ZebraNet Wireless Print Server User Guide.