User's Manual

47
Operations
Adjust Media Sensors
12/2/05 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-002 Rev. A
Lower Media Sensor
To adjust the lower media sensor, complete these steps:
1. Locate the lower media sensor assembly under the rear roller (Figure 31). The sensor is a
spring clip holding a circuit board.
Figure 31 • Lower Media Sensor Location
2. Slide the lower sensor until it is under the upper media sensor. Gently pull wires out as
needed (wires should have a little slack).
3. If you move the sensor inward and a large loop of wire develops, remove the electronics
cover from the side of the printer, and gently pull the wires through. Clamp the wires so
that they do not touch any drive belts.
1
Lower media sensor
1