User's Manual

115
Routine Maintenance
Clean the Snap Plate
12/2/05 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-002 Rev. A
RFID-Enabled and RFID-Ready Printers
Figure 51 • Snap Plate for R110Xi/R170Xi and RFID-Ready XiIIIPlus Printers
To clean the snap plate in an RFID-enabled or RFID-ready printer, complete
these steps:
1. See Figure 51. Remove the two screws that secure the snap plate to the antenna support
frame.
2. Remove the snap plate from the printer.
3. Clean the snap plate with cleaning solvent and a soft cloth.
4. To reinstall the snap plate, slide it back into place until the screw holes on the snap plate
line up with the screw holes in the antenna support frame.
5. Reinstall the two snap plate screws to secure the snap plate to the antenna support frame.
1
Antenna support screws
2
Location of right-side snap plate screw
(screw not shown)
3
Snap plate
4
Antenna support
5
Antenna support frame
6
Left-side snap plate screw
1
6
5
2
4
3
Important •
Do not remove the antenna support screws.