User's Manual

Print Modes and Options
Print Modes
98
13383L-002 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 12/2/05
9. When loading labels, allow approximately 36 in. (915 mm) of labels to extend past the
printhead. Remove all labels from this portion to create a leader.
10. Remove the hook from the rewind spindle. If you are using a core, slide it onto the rewind
spindle until it is flush against the guide plate.
11. Wind the label backing around either the 3 in. (76 mm) core or the rewind spindle.
Reinstall the hook.
12. Flip up the media supply guide. Slide in the media guide and media supply guide so they
just touch the edge of the labels. The labels should lie flat.
13. Before closing the printhead, make sure that:
• The labels are positioned against the inside guides.
• The labels are taut and parallel to the pathway when wound onto the rewind spindle or
core.
14. Close the printhead.
The labels wind on the rewind spindle or core.
15. For instructions for removing the labels from the rewind spindle, see Remove Backing or
Labels from Rewind Spindle on page 99.