User's Manual

Print Modes and Options
Print Modes
94
13383L-002 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 12/2/05
Peel-Off Mode
Peel-Off mode (Figure 40) advances one label at a time. The printer does not print another
label until the first label is removed. The
TAKE LABEL light flashes until the label is removed.
The backing is wound on the rewind spindle, but the rewind plate is not used.
Figure 40 • Media Loaded in Peel-Off Mode
To set up the printer in Peel-Off mode, complete these steps:
1. Remove the rewind plate (if installed) from the front of the printer. Store it on the two
mounting screws on the inside of the control panel.
2. From the control panel, select Peel-Off mode.
3. Open the printhead.
4. Slide the media guide and media supply guide as far from the printer frame as possible.
1
Printhead lever
2
Media guide
3
Media supply guide
4
Media
5
Media hanger
6
Guide plate
7
Spindle hook
8
Rewind spindle
9
Label backing
10
Rewind plate (removed)
11
Tear-off bar
12
Printed label
1
2
3
4
8 7
6
10
11
12
5
9