User Manual
Table Of Contents
- Contents
- Introduction
- Unpacking and Inspection
- Reporting Damage
- Getting Ready to Print
- Battery
- Installing the Battery
- Charging the Battery
- Loading the Media
- Installing the Media
- Operator Controls
- Standard Keypad
- LCD Control Panel
- Verify the Printer Is Working
- Printing a Configuration Label
- Connecting the Printer
- Cable Communications
- IR Communications
- SRRF Communications
- Zebra SRRF Network Overview
- Bluetooth™ Networking Overview
- Wireless Local Area Network (WLAN) Module Using CF Radio
- Wireless Local Area Network (WLAN) Module Using PCMCIA Radio
- Setting Up the Software
- Adjustable Shoulder Strap
- Belt Clip
- Preventive Maintenance
- Extending Battery Life
- Cleaning
- Troubleshooting
- Standard Control Panel
- Optional LCD Control Panel
- Troubleshooting Topics
- Troubleshooting Tests
- Printing a Configuration Label
- Sample Configuration Label
- Communications Diagnostics
- Calling the Help Desk
- Specifications
- Printing Specifications
- Memory/Communications Specifications
- Label Specifications
- Font/Bar Code Specifications
- Physical/Environmental/Electrical Specifications
- Communications Port
- _
- Agency Approvals
- Accessories
- Appendix A
- Interface Cables
- _
- Appendix B
- Media Supplies
- Appendix C
- Maintenance Supplies
- Appendix D
- Product Support
- Index 49
- Patent Information
QL 320 User’s Guide 19
Cable Communications
CAUTION. The power should be turned off before
connecting or disconnecting the communications cable.
All QL 320 printers can communicate by cable; the specific ca-
ble supplied with your printer will vary with the host terminal. The
8- pin circular connector on your communications cable plugs
into the serial communications port on the side of the QL 320
printer. It is keyed to assure correct alignment; do not try to force
it if it does not plug in. The other end of the cable must be
plugged into the host terminal as shown in Figure 10, or to a seri-
al port on a computer (Figure 11.) Communications between the
terminal and the printer are controlled by the applications running
on the terminal and the printer.
FIGURE 11
Communications Cable to Terminal
Part number varies. Refer to Appendix A.
QL 320
Communications Port
FIGURE 10
Serial Communications Cable to
Computer
Refer to Appendix A for part numbers.