User's Manual Part 1
4 P430i User’s Manual 980471-001 Rev. 01
Foreword
EUROPE: Norway Only: This product is also designed for IT power system with phase to phase
voltage 230V. Earth grounding is via the polarized, 3-wire power cord.
FI: “Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan”
SE: “Apparaten skall anslutas till jordat uttag”
NO: “Apparatet må tilkoples jordet stikkontakt”
Supplemental Information:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference, in which
case the user will be required to correct the interference at his own expense.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference’s by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
It is suggested that the user use only shielded and grounded cables to ensure compliance
with FCC Rules.
The user may find the following booklet, prepared by the Federal Communications
Commission, helpful:
How to identify and resolve Radio/TV Interference Problems. This booklet is available
from the U.S. Government printing Office, Washington, D.C. 20402, Stock No. 004-000-
00345-4. Use of a shielded cable is required to comply within Class B limits of Part 15 of
FCC Rules. Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this
equipment not expressly approved by Zebra may cause, harmful interference and void the
FCC authorization to operate this equipment.
Industry Canada Notice
This device complies with Industry Canada ICES-003 class A requirements.
Cet equipement est conforme a l’ICES-003 classe A de la norm Industrielle Canadian.
Model P430i conforms to the following specification: FCC Part 15, Subpart B, Section
15.107(a) and Section 15.109(a) Class A digital device.