Manualshelf

User's Manual

ManualsBrandsZebra Technologies ManualsComputers & AccessoriesTHERMAL CARD PRINTER
21222324252627282930
52 P430i User’s Manual 980470-001 Rev. A
Smart Card Contact Station
Smart Card Contact Station Interface
Smart Card Contact Station Interface
When a command to the printer interface sends a card to the Smart Card Contact Station, the printer connects
the Smart Card Contact Station to the female DB-9 connector on the rear of the printer.
An attached external Smart Card Programmer can be used to program Smart Card chips. The following table
shows the Smart Card Contact Points.
DB-9 Pin Smart Card Contact Points DB-9 Pin Smart Card Contact Points
1
C1 (VCC) 6 C6 (Vpp)
2
C2 (Reset) 7 C7 (I/O)
3
C3 (Clock) 8 C8 (RFU)
4
C4 (RFU)
9 (GND when chip is at station)
5
C5 (GND)
DB-9 Connector location for
Smart Card Contact Station