User's Manual

6 P430i User’s Manual 980470-001 Rev. A

Installation and Setup

Unpacking the Printer

Your P 4 3 0 i Card Printer ships in a carton and protective anti-static bag. Keep all packaging material in case you

need to move or re-ship the printer.

1. Inspect the shipping container to ensure that no damage has occurred during shipment. If any damage is

apparent, file a claim with the shipper.

2. Unlatch and remove the handles on either end of the shipping container, as shown in the figure below.

3. (See the figure on the next page as you perform the following steps.) Lift the upper part of the shipping

container off of the lower part (which will still hold the printer and its packing material).

4. Remove the packing material around the top of the printer.

Electric Shock Caution • Limit AC power supplied to the P430i Printer to 100 – 230

volts, 60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated

circuit breaker or other such device. Never operate the printer in a location where

operator, computer, or printer can get wet. Personal injury could result. The printer must

be connected to an earthed electrical power source and properly protected against

electrical surges and grounding faults; the electrical reliability of the printer is based on

the reliability of the mains power source and with the earth connection.

The printer’s power supply is an internal unit that can only be serviced or replaced by

trained and authorized personnel.