User's Manual

980590-001 Rev. A Draft 1 P100i User’s Manual 7
2
Printer Installation
Installing the P100i Printer
1. Place the printer in a location that allows easy access to all sides. The printer should
never be operated while resting on its side or upside down
2. Remove the yellow CAUTION label from the back of the printer.
Caution • Do not power the printer with USB attached to your computer at this
time.
THE DRIVER WILL PROMPT YOU WHEN IT IS TIME TO PLUG IN AND POWER
UP YOUR PRINTER.
Caution • Limit electrical power supplied to the P100i Printer to 24 VDC. Limit
excess current draw to 16 amps or less, using an associated circuit breaker or
other such device. Never operate the printer in a location where operator,
computer, or printer can get wet. Personal injury could result. The printer must be
connected to an earthed electrical power supply and properly protected against
electrical surges and grounding faults. The power supply pack can only be
replaced by the same product from the manufacturer.