User's Manual

Beacon Hardware Specifications and Installation 2 - 27

• Do not use incompatible batteries and chargers. Use of an incompatible battery or charger may present a risk of fire,

explosion, leakage or other hazard. If you have any questions about the compatibility of a battery or a charger, contact Zebra

Support.

• Do not disassemble, open, crush, bend or deform, puncture or shred the badge or charger

• Impact from dropping the badge and charger on a hard surface could cause the battery to overheat.

• Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.

• Do not modify, remanufacture, insert foreign objects into the battery, immerse or expose to water or other liquids, or expose

to fire, explosion or other hazard.

• Do not leave or store the equipment in or near areas that might get very hot, such as in a parked vehicle or near a radiator

or other heat source. Do not place battery into a microwave oven or dryer

• If you suspect damage to your equipment or battery, contact Zebra Support to arrange for inspection.

2.12.2 Cleaning the Charging Cradle

The following materials are required to clean the charging cradle:

• Alcohol wipes

• Cotton tipped applicators

• Can of compressed air

Cleaning frequency is discretionary in respect to the environments the charger and the badges are deployed. They may be

cleaned as frequently as required.

2.12.2.1 Cleaning the Badge Contacts

To clean the contacts on a badge before inserting into the charging cradle:

1. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.

2. Rub the cotton portion of the cotton tipped applicator back-and-forth across the contacts. Do not leave any cotton residue

on the contacts (repeat at least three times).

3. Use a dry cotton tipped applicator to clean any moisture or residue remaining on the contacts.

4. Spray compressed air on the contact area by pointing the nozzle about ½ inch away from the surface.

5. Inspect the area for any grease or dirt, repeat this process if required.

2.12.2.2 Cleaning the Cradle Connectors

To clean the connectors within the cradle:

1. Remove DC power cable from the cradle.

2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.

3. Rub the cotton portion of the applicator along the connector pins. Slowly move the applicator back-and-forth on the

connector to the other. Do not leave any cotton residue on the connector. All sides of the connector should also be rubbed

with the cotton tipped applicator.

4. Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away from the surface.

5. Ensure there is no lint left by the cotton tipped applicator, remove any lint if found.

6. If grease or other dirt can be found on other areas of the cradle, use a lint free cloth and alcohol to remove.