User's Manual

2 - 22 MPact Location & Analytics Hardware Installation Guide
Figure 2-25 GE-MB5001-01-WR
• Reboot the badge - Press and hold button 2 between 10 and 20 seconds, then release. LED 1 will blink slowly twice to
confirm. Any in-process configuration activity will need to be re-started.
• Erase to factory default configuration and reboot - Press and hold button 2 between 30 and 40 seconds, then release.
LED 1 will blink slowly twice to confirm. The deletion of the initial configuration could be warranted if the configuration
was not successfully applied on the first attempt. Once reverted to factory configuration, the initial config and scanning
config can be re-applied.
• Shutdown the badge - Press and hold button 2 between 20 and 30 seconds, then release. LEDs will blink 5 times to
confirm the badge shutdown. Use this process when brining a deployed badge offline.