User's Manual

Beacon Hardware Specifications and Installation 2 - 17

01 asset beacon. The beacon is attached to the mounting plastic using the adhesive strip, then a tie wrap is used to connect

the mounting plastic to the hand tool.

Figure 2-20 GE-MB1000-01-ACC Beacon Accessory

To mount the asset beacon using the GE-MB1000-01-ACC beacon accessory:

1. Peel the tape from the adhesive pads on the rear of the asset beacon and press the unit to the mounting surface on the

accessory GE-MB1000-01-ACC. The adhesive is immediately bonding and reaches full adhesion within an hour.

Figure 2-21 GE-MB1000-01-ACC Beacon Accessory

NOTE: The beacon can also be mounted using a lanyard or zip tie.

NOTE: Once adhered to a surface, its very difficult to remove. The beacon’s adhesive

pads will need to be replaced if it is moved to a new location. The part number for

replacement tape is GE-MB1000-TAPE.