User's Manual

Beacon Hardware Specifications and Installation 2 - 13

2.7.2.2 Mounting Outdoor Style Beacon

To mount a Outdoor Style beacon with 3M™ VHB™ tape:

1. Peel the plastic off from 3M™ VHB™ tape.

2. Press the backside of the Outdoor Style beacon firmly to a smooth clean mounting surface.

To mount a Outdoor Style beacon with No. 6 gauge or M3.5 screws:

1. Press the backside of the beacon to the mounting surface.

2. Insert screws into the screw holes as shown in Figure 2-15 on page 2-13.

3. Hand tighten the screws to firmly secure the beacon.

Figure 2-14 Back of Outdoor Style Beacon Outdoor Beacon

Figure 2-15 Top of Outdoor Style Beacon - MPACT-MB4000-01-WR

NOTE: Zebra recommends not removing the plastic backside of the 3M tape when

mounting the beacon with screws.

NOTE: Ensure the beacon is positioned correctly. Once the beacon is mounted it should

difficult to remove.

NOTE: On MPACT-MB4000-01-WR model outddor beacons, the red antenna pattern

indicates that the antenna is pointing down.