Installation Guide

MPact Location & Analytics Hardware Installation Guide
36 MN-002947-01
2.13.3 Battery Charging Guidelines
Failure to follow these guidelines may result in fire, explosion or other hazard.
• The area in which the units are charged should be clear of debris and combustible materials or chemicals. Particular care
should be taken when charging in a non commercial environment.
• To charge the battery, the battery and charger temperatures must be between 0 - 40 degrees Celsius.
• Do not use incompatible batteries and chargers. Use of an incompatible battery or charger may present a risk of fire,
explosion, leakage or other hazard. If you have any questions about the compatibility of a battery or a charger, contact Zebra
Support.
• Do not disassemble, open, crush, bend or deform, puncture or shred the badge or charger
• Impact from dropping the badge and charger on a hard surface could cause the battery to overheat.
• Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
• Do not modify, remanufacture, insert foreign objects into the battery, immerse or expose to water or other liquids, or expose
to fire, explosion or other hazard.
• Do not leave or store the equipment in or near areas that might get very hot, such as in a parked vehicle or near a radiator
or other heat source. Do not place battery into a microwave oven or dryer
• If you suspect damage to your equipment or battery, contact Zebra Support to arrange for inspection.